作业帮静平衡检验在轴辊式平衡器上进行,平衡器的两根钢轴直径应相等,其表面粗糙度为Ra0.32 mm.硬度不低于50HRC,两根轴应处于水平位置并在同一水平面上.检验用平衡心轴表面粗糙度为Ra0.63 mm ,硬度
来源：学生作业帮助网 编辑：作业帮 时间：2024/04/29 15:28:43
静平衡检验在轴辊式平衡器上进行,平衡器的两根钢轴直径应相等,其表面粗糙度为Ra0.32 mm.硬度不低于50HRC,两根轴应处于水平位置并在同一水平面上.检验用平衡心轴表面粗糙度为Ra0.63 mm ,硬度
静平衡检验在轴辊式平衡器上进行,平衡器的两根钢轴直径应相等,其表面粗糙度为Ra0.32 mm.硬度不低于50HRC,两根轴应处于水平位置并在同一水平面上.检验用平衡心轴表面粗糙度为Ra0.63 mm ,硬度不低于50HRC,并预先经过平衡.
静平衡检验在轴辊式平衡器上进行,平衡器的两根钢轴直径应相等,其表面粗糙度为Ra0.32 mm.硬度不低于50HRC,两根轴应处于水平位置并在同一水平面上.检验用平衡心轴表面粗糙度为Ra0.63 mm ,硬度
Static balance test in the axis of roller of balancer on balance,two of the steel shaft diameter should be equal,its surface roughness as Ra0.32 mm.Hardness is not less than 50 HRC,two shaft should be in a horizontal position and in the same horizontal plane.Inspection with balance surface roughness as Ra0.63 heart shaft mm,hardness,and no less than 50 HRC in advance through balance.
Static balance test in the roll axis on the balancer, balancer shaft diameter should be equal to two steel, the surface roughness of Ra0.32 mm. Hardness of not less than 50HRC, two shafts should be in...
全部展开
Static balance test in the roll axis on the balancer, balancer shaft diameter should be equal to two steel, the surface roughness of Ra0.32 mm. Hardness of not less than 50HRC, two shafts should be in horizontal position and at the same horizontal plane. Test with the balance of the surface roughness of mandrel Ra0.63 mm, hardness of not less than 50HRC, and advance through the balance.
收起